Handheld electric hot knife fabric cutter is suitable for cutting Terylene Fabrics, Polyester Fabrics, Printing fabric and Window Curtain Fabric. With sharp blade heating up in seconds, the hot knife is a most efficient hand-hold cutter for cutting synthetic fabrics. The hot cutter can cut and seal the material at the same time and the edge of the fabric is sealed smoothly.

Features

• Designed for cutting small quantities, short-time use only.
• Lightweight electric hot knife with sharp blade, fast and clean cutting
• Temperature of blade can heat up to 500℃ in seconds.
• With 16 steps adjustment to control temperature
• Especially suitable for cutting and sealing synthetic fabric efficiently
• Also used for cutting glue edge of solar photovoltaic glass

Specification

Note:

* Usually, the foam cutters with UK/Australia need longer delivery time (5-10 days).

Applications

Tips: Hot Knife Foam/Fabric Cutter Operation Cautions

1. Avoid direct contact between the two blade holders to cause a short circuit.
2. Turn the temperature adjustment knob to the middle position, place the blade on the cutting object, and then press the trigger. The hot knife is preheated for a few seconds to cut. It is recommended to do the cutting test on the waste material first.
3. It is best to keep the temperature and speed in harmony when cutting. If there is too much smoke, it may be because the cutting speed is too slow or the blade temperature is too high. This may cause irregular and uneven cutting trajectories. In this case, you can reduce the blade temperature or release the switch intermittently during cutting. When cutting, the exposed part of the blade should not exceed 2 cm. If the exposed part is too much, the blade may be bent due to overheating.
4. Clean the blade with a cleaning brush.