Buy 750W 380 volt high-power vortex blower for industrial suction, aquaculture, textile industry, etc. The quality is good but the price is low.

Specification

Dimention (Unit: mm)

Tips: High pressure regenerative blowers installation tips

• Use flat washers and spring washers to tighten the screws.
• It is best to use rubber buffer rubber to withstand the weight of high pressure blowers, especially for high power regenerative blowers, rubber buffer rubber is essential.
• For some occasions that have requirements for noise, a silencer can be installed to reduce the noise (in general, it is reduced by about 5dB), and the silencer is installed at the end of the air inlet pipe or the air outlet pipe.
• For some occasions with high requirements for noise, a layer of silencer sponge can be added according to the conditions of the high pressure regenerative blower itself to meet the noise requirements on site.
• When using silencing foam, pay attention to the distance between the high pressure regenerative blower and the cabinet, and pay attention to the ventilation and heat dissipation of the high pressure vortex blower.
• The inlet and outlet pipes of the high pressure blower should be connected with hoses to isolate vibration.